Tension Cable Home Depot . The chain link fence tension wire stretches to 170 linear feet. Cart sign in quick order contact us. YARDGARD 170 ft. Galvanized Tension Wire328787DPT The Home Depot from www.homedepot.com The chain link fence tension wire stretches to 170 linear feet. National hardware 1/2 x 6 steel eye and eye turnbuckle. Like all construction methods, the post tension cable system.
How To Disconnect Ribbon Cable Blu Ray. Don't break the interface clip and ruin your playstation 3. On the print head, slide the cable clip (indicated below) away from the print head.
PlayStation 3 BluRay Drive Replacement iFixit from www.ifixit.com
There appear to be contacts, and the conductive tracks showing through the ribbon appear to have width, so. These models are more tricky than the rest of the slims b. To remove it, use a spudger or fingernail to lift the clear blue tab away from the connector.
How Do I Take Off A Ribbon Cable?
Can you show an end view of the black block? Untape and open the visor. Of course, the thickness of the plastic sheet is very important, your.
If So, The Following Should Work.
The ribbons transfer data to and from the drive. I don't have any knowledge on these matters so i need help on how to go about repairing this. Pinch the tabs on the ribbon cable connector to disconnect the.
The Warm Board Works Syndrome.
That does not look like the. There appear to be contacts, and the conductive tracks showing through the ribbon appear to have width, so it does look like a. There appear to be contacts, and the conductive tracks showing through the ribbon appear to have width, so.
Discussion Of Proper Reattachment Of A Ps3 Bluray Drive Ribbon Cable To The System Board.
Looking at the left, it does seem. Can you show an end view of the black block? I found this ribon connection but it goes into a connection i have never seen before.
Like From The Laser Reading The Disc To The Console, And From The Console To The Motors In The Drive.
These models are more tricky than the rest of the slims b. And put a fairly large blob yes blob of solder on the tip of your iron, andget some clamps ready and clamped on the ribbon cable. You need to cut the plastic sheet to the same width than the ribbon cable and insert both inside the connector.
Comments
Post a Comment